Upon startup all lights blinking / no sound.

[Jack]

Hello,

I've owned my OB-6 a few weeks with no problems. It sits in an airconditioned room daily.

I went a day not using it and this evening, when I turned it on, the entire board started blinking rapidly. I let it go and this did not stop. I eventually turned it off then did the recommended calibration steps.

This room is cool at 70 degrees and the device has been on for half an hour. Get no sound.

I ran calibration again and still no sound.

It has been in a cool to a cold room since I got it and this had previously not been an issue.

Any suggestions?

Thanks,
Jack

[AlainHubert]

Hello,

I've owned my OB-6 a few weeks with no problems. It sits in an airconditioned room daily.

I went a day not using it and this evening, when I turned it on, the entire board started blinking rapidly. I let it go and this did not stop. I eventually turned it off then did the recommended calibration steps.

This room is cool at 70 degrees and the device has been on for half an hour. Get no sound.

I ran calibration again and still no sound.

It has been in a cool to a cold room since I got it and this had previously not been an issue.

Any suggestions?

Thanks,
Jack

Sorry to hear that. My best suggestion would be to contact DSI support by email ASAP.
support@davesmithinstruments.com

[Jack]

Thanks, I will do that.

[AlainHubert]

Thanks, I will do that.

Any news from them ?