The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Pro 3 => Topic started by: gm.rixes on August 02, 2023, 05:18:03 PM
-
Hello everyone,
I own a Pro-3 with Cubase 11 in DAW, but I'm stalling on a question:
I want to drive my Waldorf Pulse.2 + My uno synth pro FROM my Pro-3.
Of course, CCs are not the same... Cutoff = 33 for the Pro-3, against 35 for the UNO....
Cubase Solution's : the insert midi plugin "miditransformer" in cubase... = horrible... :'(
4 lines of commands for a single CC... Means 48 lines to drive the 4 points of each of the 3 Pro-3 envelopes to the Waldorf... arfff.... :'(
I don't want to change 4 or five buttons , but most all of them.
Do you have any tips ? Or do you know of any plug-ins or products that can do this?
I see it as a midi plugin with a GUi where there would be buttons, faders etc... that you click and affect CC in then CC out...
A bit like arturia's BeatStep and its Midi Control Center with GUi to allow CC transformation ...
Any ideas or suggestions?
Best regards,
Gaëtan.
-
Bome's MIDI translaror
-
Bome's MIDI translaror
Thank you for your answer, I find it (le programme) a little non-intuitive...
I discover this one wich help me well :
https://www.bluecataudio.com/Products/Product_RemoteControl/
Hope it helps !
Regards,
Gaëtan/