Using my pro-3 to drive my other hardware synths ?

[gm.rixes]

Hello everyone,

I own a Pro-3  with Cubase 11 in DAW, but I'm stalling on a question:
I want to drive my Waldorf Pulse.2 + My uno synth pro FROM my  Pro-3.

Of course, CCs are not the same... Cutoff = 33 for the Pro-3, against 35 for the UNO....

Cubase Solution's : the insert midi plugin "miditransformer" in cubase... = horrible...   
4 lines of commands for a single CC...  Means 48 lines to drive the 4 points of each of the 3 Pro-3  envelopes to the Waldorf... arfff....   
I don't want to change 4 or five buttons , but most all of them.

Do you have any tips ? Or do you know of any plug-ins or products that can do this?

I see it as a midi plugin with a GUi where there would be buttons, faders etc... that you click and affect CC in then CC out...
A bit like arturia's BeatStep and its Midi Control Center with GUi to allow CC transformation ...
Any ideas or suggestions?

Best regards,

Gaëtan.

[RadekPilich]

Bome's MIDI translaror

[gm.rixes]

Bome's MIDI translaror

Thank you for your answer, I find it (le programme) a little non-intuitive...
I discover this one wich help me well :
https://www.bluecataudio.com/Products/Product_RemoteControl/

Hope it helps !

Regards,
Gaëtan/