Key commands

[Analog Prophet]

Have not seen this in the manual:

- While holding down Global and selet Program 5 (the global option buttons) there is an option that says 000 and can be set to + or - values. What is that?

- When then hit one more time it says Jup, what is that?

[ArjandeRooy]

My guess is the Velocity Response Curve. Check the light to see what globals mode you'r in.

Best,
Arjan

[Analog Prophet]

Check the light to see what globals mode you'r in.

This isnt Global 1 or 2 but another mode while holding down Global and anlther key, for instanser Global + 1 show the Firmware version. My question is in this mode but Global + 5.

[gus]

Have not seen this in the manual:

- While holding down Global and selet Program 5 (the global option buttons) there is an option that says 000 and can be set to + or - values. What is that?

- When then hit one more time it says Jup, what is that?

Global + 5 is for CV calibration - more details on Page 54 of the manual. It gets cal'd from the factory, so you generally shouldn't have to adjust these settings.

Enter cv cal mode   "Hold Global + 5
2) Prog 1 = CV out lo; 2 = CV out high; 3=CV in lo; 4= CV in high . Inc/Dec to change value
3) Hitting 5 does cv in auto cal
4) Hitting 8 exits cal mode, at any time"

[Analog Prophet]

Thank you very much for clearing this out!