well I'm outta bugs now anyone got anything they want helping trying to resolve???
Good job Carson! (and anyone else at DSI still working on this!!!)
These two items still being worked on I believe as I had confirmation of them, could be an invasive fix as I have had no email updates on progress so far. But, great that things are slowly being worked out. Thanks guys.
BUG – BEAT TRANSITION
Power cycle Tempest
Load Factory Project (I am using Bag & Glow)
Initialize Project
Reset System Parameters
Press ’SYSTEM’ again
Check System Swing set as BEAT
In 16 BEATS MODE enter the following SWING data into the pads
A1 – 56.3%
A2 – 60.4%
A3 – 64.6%
Select ‘BEAT PAD ‘A1
Press ‘ERASE’ and ‘COPY’ to enter ‘EDIT’ mode and select ’10. Change Time Signature’ and set the following BEAT/TIME SIGNATURE data.
A1 – 4/4 8 Bars
Select ‘BEAT PAD ‘A2
Press ‘ERASE’ and ‘COPY’ to enter ‘EDIT’ mode and select ’10. Change Time Signature’ and enter the following BEAT/TIME SIGNATURE data.
A2 – 4/4 6 Bars
Select ‘BEAT PAD ‘A3
Press ‘ERASE’ and ‘COPY’ to enter ‘EDIT’ mode and select ’10. Change Time Signature’ and enter the following BEAT/TIME SIGNATURE data.
A3 – 4/4 4 Bars
Press ‘PLAY LIST’ and ‘EVENTS’ to enter Play List Mode
Enter the following Steps
1 | 1/Basic Beat – 8 Bars (Bar 1)
2 | 2/Basic Beat – 6 Bars (Bar 9)
3 | 3/Basic Beat – 4 Bars (Bar 15)
Ensure the ‘END’ (soft knob 4 is set to ‘Loop to Step 1’
PRESS PLAY… (Note: I’ve had it freeze here a couple of time when Play pressed, but this is very rare).
About once every 6 plays of the ‘LOOP’ you will get a skip (I have actually gone quite a while before loops skips).
You will have to concentrate and watch the time stamp. The skip usually happens at Bar 8 and skips to Bar 13 or Bar 14 and skips to Bar 17
BUG – STOP: END PLAY
1. Power cycle your Tempest.
2. Load any Factory Project.
3. Initialize a new Project.
4. Select any Beat.
5. Change it’s Time Signature.
6. Choose 4/4 2 bar (although I think any time signature will do)
7. Go into the Beat Events screen.
8. Select any sound and insert a single step at the beginning of the very first bar.
9. Go to Play List and select the Beat you just edited as the first and only Step in the Play List and make it play for 2 bars.
10. Select ‘End: Stop Playback’ as playback mode.
11. Press Play.
RESULT:
Play List starts the bar and plays the sound at 1.1.1 as it should, but also at the end of the bar at 2.4.73 when it stops.