Hello all,
I got my new PRO3 today and the following MIDI problems have appeared (firmware 1.1.2.8 is installed):
- MIDI via USB does not work at all (I tried different cables and 2 different PCs, global settings reset several times and each time set correctly.
- MIDI via 5-pin MIDI cable works. Tried to install the firmware "Main 1.2.0.2" with MIDI-OX. The export of the Sysex file worked, the PRO3 has "installed" to 100%, then immediately the last program was displayed again. Have then switched power off and on again, but the synth was still at 1.1.2.8.
Repeated it again, with the same result.
What can I have done wrong?
Thanks for any advice!