After a week with my new P12 Module I realized that I can control the P12 with my Pro2 but I’m afraid I can not use both Synths simultaneously, or is there a way?
I have a Novation Remote SL 37 MK II which I didn’t used for a long time but hey, I think it can be a nice controller for the P12? So I’ve started to make a template...
I just spend over two hours to find out how to map the remote controls to the P12 but I’m not really successful. I can map them with CC but I’m not be able to map them with NRPN. The P12 will not respond. I never mapped NRPN parameters before, so I’m not an experienced user...
I’ve noticed that also the CC mapping is also not working perfectly and I don’t know how I can fix it. For example:
I mapped LPF Freq (CC102) and when I turn the knob on the Remote the Display on the Remote will show a max value of 127 while the P12 shows me 164. I think there is something wrong with my settings. Also the Remote is not responding when I turn a knob at the P12, hmm, I think I miss something...
What about the NRPN controls?
In the Manual is Said that NRPN is the best way to control the P12?
According the Manual LPF Freq must set to NRPN 90 (layer a) and 602 (layer b), Value 0-164.
When I try this to setup on the Remote SL the P12 doesn’t respond and I don’t know why. Can anybody please help how to set this up?
Below is a photo with the setting page from the Remote SL.
Sorry for this beginner question, but after a few hours try and error, I need to ask the specialists.
Thanks a lot for your feedback!