The process to install the hard drive is relatively easy and requires no more than a screwdriver to perform. Start by removing any power, audio, MIDI/USB, and/or pedal connectivity from the synth.
1. Remove the 3 screws in each wood end. Remove the wood ends.
(see attached WoodSideLeft.jpeg, Wood SideRight.jpg)
2. Place a piece of soft material down and flip the instrument over face down on top of the material.
3. Remove the 2 screws which hold the wheel box to the metal underside. The first screw is located immediately to the right, and slightly down, from the left front rubber foot.
(see attached WheelToMetalScrews.jpeg)
4. Remove the 4 screws which hold the hard drive to the metal work.
(see attached HardDriveScrews.jpg)
5. Flip the instrument back over. Remove the 3 screws on the left side, and the 2 screws on the rights side of the synth.
(see attached ScrewsLeftSide.jpeg, ScrewsRightSide.jpeg)
6. The front panel can now be flipped open. The panel is hinged at the rear and has a lanyard to keep the top panel in place.
7. Remove the SATA and power cable from the hard drive and replace the hard drive.
Reassemble the synth in the reverse order of disassembly.