Help! OB-6 with Linnstrument issues

Started by elizabethwelker, June 21, 2026, 01:02:21 AM

1 Replies 10,208 Views

elizabethwelker

*
Commerce
Posts: 1
Logged
Does anyone else have this setup?

I'm using a LinnStrument with MPE enabled (Channel Per Note, Per-Note Y enabled, MIDI channels 1–7). Everything works as expected in normal operation. However, when I enable Unison mode, MPE starts behaving strangely. Only one voice responds correctly to pitch bend. I can bend the first voice, but then I have to cycle through the other five voices before pitch bend works again.

Is this a known issue or expected behavior with Unison mode and MPE? Could I be missing a setting somewhere?

I bought this unit used, so I'm also trying to determine whether this is a configuration problem, a firmware issue, or potentially a hardware fault before my return window expires.

Any insights would be appreciated. Thanks!
Last edited by bad time simulator a day ago

Soundquest

***
Full Member
Posts: 968
Location: Ohio, USA
Logged
Never tried the Linn with unison on any synth, but  works fine un poly mode w. OB6.  I'm guessing it's not an OB6 instrument fault, perhaps just limitation.   Sometimes the linn is a little tricky to set up on certain instruments.
Sequential/DSI Equipment: Poly Evolver Keyboard, Evolver desktop,   Pro-2, Pro-3, OB6, P-12,
 

https://soundcloud.com/wavescape-1