No LED red dot on filter cut-off

[Mattog]

Is it just my machine or does the TEO-5 not show the red dot in the LED panel when you arrive on the filter cut-off's programmed value. Every other knob and button shows the dot except for this. I've played around with pass-thru, relative, and jump, hoping this might rectify the problem, but to no avail. It wouldn't be so bad if the values were shown in the main screen, but at the moment I have no idea what the original value is, other than to try and line it up by ear by repeatedly alternating between the compare button.

[Quatschmacher]

If this is the case, email support@sequential.com to report it and it’ll get fixed.

[Mattog]

If this is the case, email support@sequential.com to report it and it’ll get fixed.

I assume you're TEO-5 doesn't exhibit this behaviour?

[Mattog]

Is it just my machine or does the TEO-5 not show the red dot in the LED panel when you arrive on the filter cut-off's programmed value. Every other knob and button shows the dot except for this. I've played around with pass-thru, relative, and jump, hoping this might rectify the problem, but to no avail. It wouldn't be so bad if the values were shown in the main screen, but at the moment I have no idea what the original value is, other than to try and line it up by ear by repeatedly alternating between the compare button.

I think I may have found the answer to my own question - human error! Because the resolution on the filter cut-off is so fine, the dot appears but within a much tighter tolerance than with the other parameters/knobs. So even with a slow turn, you can end up skipping past the programmed setting fast enough for the dot not to register. To find the dot/setting you really need to make super fine adjustments, much more so than any other synth I've encountered (again, I wish the parameter values were displayed in the main screen).

[Quatschmacher]

If this is the case, email support@sequential.com to report it and it’ll get fixed.

I assume you're TEO-5 doesn't exhibit this behaviour?

I don’t own one. With all these things it’s best to contact support straight away as if there’s a firmware issue it is the only guaranteed way to get the report seen.

Glad you’re is working as expected.

[Ronny Cash]

to be honest, I cannot see a red dot in the display on any parameter? Where is it on the display exactly?

[Quatschmacher]

to be honest, I cannot see a red dot in the display on any parameter? Where is it on the display exactly?

In the red 7-segment display area where the patch number is shown. It only appears when you move a control to match the saved position in the preset.