I’ve had my Take 5 for a few weeks now, and have noticed a potential glitch in my firmware.
The synth will be operating normally, but I will try to save a new patch to the user bank or something else involving the light up Factory or Bank buttons, and suddenly the whole synth will freeze up - I can’t change banks, turn on or off the sequencer, change octaves etc. This would lead me to believe that it’s something to do with the light up buttons, but I’m at a bit of a loss. It’s remedied by a good ole turn off and reboot.
It doesn’t happen often, but often enough that I want to make sure it’ll either a.) Get ironed out as I continue regularly recalibrating the synth since it’s new, or b.) If I need to send it in for repair. Any help would be appreciated!
Edit: Happened again just now - can’t control any of the knobs or parameters, it’s stuck playing the sequence and I can’t turn it off without turning off the whole unit!