Mappable page 2 parameters in panel control

Mappable page 2 parameters in panel control
« on: May 18, 2023, 08:38:21 AM »
I'm not an OBX8 owner but I hope to soon be.

I've been trying to find what parameters of page 2 are mapped to the panel controls in the manual, but I'm unable find these details.

It would be cool if you could map what page 2 parameters go to each panel control. For example, 2nd page cutoff control mapped to the filter type.

Some may want their page 2 osc 1 freq control mapped to osc 1 level, or sometimes you may want it mapped to osc 1 pulse-width instead.

Going further, imagine if these mappings could be saved per program (if desired, maybe alternatively they could be saved globally). You may have a program with a lot of modulation where you would want to be adjusting page 2 panel controls of the envelope mapped to modulation primarily, where another program you would want the standard page 2 panel control mappings.

Thoughts? I think this would be cool.

Re: Mappable page 2 parameters in panel control
« Reply #1 on: May 23, 2023, 08:13:23 PM »
Also, when panel mode is enabled in global settings, what are the panel controls mapped to? I can't seem to find this info in the manual.

Thanks for any info.