The Official Sequential/DSI Forum

OB-6 MPE Not working after update

OB-6 MPE Not working after update
« on: January 20, 2021, 08:17:12 PM »
Hey everyone,

Maybe I'm missing something small or large I just can't figure it out.  OB-6 updated first try.  It reads 1.6.4 on startup.  I reset the globals, followed all the instructions on turning MPE on, 3rd bank of globals, assigning y-axis, etc.  However, for the life of me I cannot get the MPE to work with a Launchpad Pro MKIII. 

The aftertouch works perfectly so I know it can't be the Launchpad itself. 

Is anyone else having this problem?  I have re-updated, re-reset globals and went through the whole process again and I'm still having trouble.  Any suggestions would be most helpful. 



Re: OB-6 MPE Not working after update
« Reply #1 on: January 20, 2021, 09:22:42 PM »
But the pads on the Launchpad Pro only sense velocity and pressure, and do not sense movement or transmit MIDI CC data on the X (pitch) or Y (modwheel/CC74) axes.  Therefore, it cannot be used as an MPE controller.