CV loopback

CV loopback
« on: September 24, 2020, 09:59:35 AM »
Has anyone tried routing the CV to itself? (CV Loopback)

I’m messing with this, and getting interesting results, but fully admit I don’t know what I’m doing :laughing:

What I did was connect a mono TS cable from CV out 1 to CV in 1.
In the mod matrix, I then sent OSC1 to CV 1 Out, and CV In 1 to OSC1 ShapeMod.

I’m hearing differences vs doing this without CV, but it could just be that the ranges are different.

Best regards,

Gino