Aftertouch not working

Aftertouch not working
« on: August 26, 2020, 10:42:45 AM »
Hi Everyone,

On my Pro 3 I can not seem to get aftertouch to work.
I've enabled it in the global settings, and mapped pressure to pitch to test it.

I use AT on other synths, and ran into this while recreating a patch.

Any ideas?

Best regards,

Gino


Re: Aftertouch not working
« Reply #1 on: August 26, 2020, 11:49:28 AM »
Hi Everyone,

On my Pro 3 I can not seem to get aftertouch to work.
I've enabled it in the global settings, and mapped pressure to pitch to test it.

I use AT on other synths, and ran into this while recreating a patch.

Any ideas?

Best regards,

Gino

Mapping to pitch is a good idea to test it, as it should be easily apparent.   Try with some extreme settings to check and make sure its working:

Mod Matrix:
Source:  Pressure
Dest:  Osc All Course
Amount:  100

If that doesn't work, you might need to contact support.

OB-X8, Pro 3, P6, Rev2, Take 5, 3rd Wave, Deepmind, PolyBrute, Sub 37
Sound Sets:
https://sounddesign.sellfy.store/
Free Patches:
https://www.PresetPatch.com/user/CreativeSpiral

Re: Aftertouch not working
« Reply #2 on: August 26, 2020, 11:52:47 AM »
Thanks. No luck, so I'll contact support.

Re: Aftertouch not working
« Reply #3 on: August 26, 2020, 06:00:47 PM »
Support had me open it up, and it was a loose ribbon connector.

AT is now working!