The Official Sequential/DSI Forum

Problem when using NRPN

Problem when using NRPN
« on: February 05, 2020, 05:34:32 AM »
Hello! Does anyone have experience controlling Tetra via NRPN? How does it work? When I turn any MIDI controller knob, the value jumps from 0 to 127 with no intermediate values. But when I use CC messages, everything works well. How do I set up smooth parameter changes? I use beatstep pro and novation remote 37 sl, the result is the same  :(

« Last Edit: February 05, 2020, 06:34:56 AM by vladimirdvornikof »

Re: Problem when using NRPN
« Reply #1 on: February 05, 2020, 02:45:12 PM »
Are those controllers sending NRPN or CC?

Re: Problem when using NRPN
« Reply #2 on: February 06, 2020, 02:13:15 AM »
These controllers send CC and NRPN. I tried both options, but the NRPN doesn't work correctly, it jumps from the minimum value to the maximum value, only 0 or 127

Re: Problem when using NRPN
« Reply #3 on: February 06, 2020, 05:20:51 AM »
hmm. i don’t know, then. the only time i’ve used nrpn was when i was programming a tetra from a mopho x4

Re: Problem when using NRPN
« Reply #4 on: February 12, 2020, 09:25:51 AM »
I am controlling my Tetr4 with two BCR2000 controllers, and NRPN messages are working fine.
Only problem is you canīt see the values you are adjusting  on the Tetrīs display when in Multimode. Not sure if this can be fixed, or maybe it's just me who don't know how to setup my controllers correctly.

What controller and software do you use? 
Lars