The Official Sequential/DSI Forum

How to Access Delay Modes

How to Access Delay Modes
« on: July 24, 2019, 10:56:57 PM »
Hey everyone, I'm new to the Prophet 12 and just read through the manual but I can't figure out how to access the delay feedback modes. When I click one of the delay knobs, in the menu only appears "delay time", "sync", "amount", and "feedback". The soft knobs only control the amounts of the 4 aforementioned parameters and the buttons underneath the menu don't do anything. What am I missing? Thanks!

Sloej

Re: How to Access Delay Modes
« Reply #1 on: July 25, 2019, 04:01:05 AM »
What’s in the bottom right corner of the screen?
Right-hand button is for Fdbk Mode.

« Last Edit: July 25, 2019, 04:19:24 AM by Sloej »

Re: How to Access Delay Modes
« Reply #2 on: July 25, 2019, 04:06:50 AM »
Hey there, welcome to the Prophet Fam!

There are 4 Soft buttons located right below the display to navigate through different sets of parameters (Pages)
of the Section/Module (e.g. Oscillators, Filter, Delay, etc.) you want to configurate.
By default you enter the first of those pages when turning a knob or pressing a button of the delay section.

You can reach a second set of Parameters for the delays by pressing the second "soft" button from the left.
This gets you on the Page where u can control the Highpass- and Lowpassfilter of the delay as well as panning and you´re demanded parameter the FeedbackMode.

hope this helps you,
cheers and have fun jamming