A program has 2 layers, A and B.
Each layer can contain a different patch.
Layers can be combines as splits and stacks.
If you plug additional cables into Output B, the sound of B will be sent to Output B, for separate layering of the two layers.
Multimode allows separate MIDI control of voices 1-4 and 5-8. This enables independent, bi-timbral control of the Prophet.
Multimode is intended for use with an external sequencer controller.
When Multimode is On, the '08 responds to MIDI data on 2 consecutive MIDI channels. The base channel controls voices 1-4 and the other channel controls voices 5-8.
1) So would I be able to have a 4-voice stereo Lead and a 4-voice stereo Pad sound playing at the same time on the '08 (that would be 8 voices total), with the lead outputting through stereo output 1 and the pad sound outputting through stereo output 2?
2) And be able to sequence lead on MIDI Channel 1 of an MPC and the pad on MIDI Channel 2 of the MPC?
3) And could I route the '08's outputs to my Mackie Onyx 1220i mixer like the following?:
08 Out 1 L -> Mixer mono ch 1 ;panned hard left
08 Out 1 R -> Mixer mono ch 2 ;panned hard right
('08 Stereo out 1 would be outputting L & R channels of 4-voice stereo Lead sound)
08 Out 2 L -> Mixer mono ch 3 ;panned hard left
08 Out 2 R -> Mixer mono ch 4 ;panned hard right
('08 Stereo out 2 would be outputting L & R channels of 4-voice stereo Pad sound)
Thanks so much for any help! Take care