Pan A/B

[husker]

I'm new to the Rev2, and am going through the manual now.  One thing I can't figure out (which I think should be easy).

How would I, for example, and Layer A only to the left, and Layer B only to the right?

I think this should be simple, but it has thus far escaped me.

Thank you.

[creativespiral]

1. Switch each Layer's Pan Mode from Alternate to "Fixed"

2. In Modulation Matrix for each layer, set:

Source: DC
Destination: Amp > Pan Spread
Value: You can use -32 on one side, and +32 on the other side.   +/-32 seems to be enough to hard pan... I'm not sure why its that low. 

[guyaguy]

Or, to point out the obvious, use the separate Layer A and B outputs and pan in your mixer or DAW.

[husker]

1. Switch each Layer's Pan Mode from Alternate to "Fixed"

2. In Modulation Matrix for each layer, set:

Source: DC
Destination: Amp > Pan Spread
Value: You can use -32 on one side, and +32 on the other side.   +/-32 seems to be enough to hard pan... I'm not sure why its that low.

Perfect, thank you.   It was the "fixed mode" that I was missing.

[S Y Z Y G Y X]

That’s one thing I love about this synth, being able to pan each layer and using different frequencies of the filter and such on both layers you really get such a sweet stereo image