The Official Sequential/DSI Forum

Saving a snapshot with Sysex?

Saving a snapshot with Sysex?
« on: February 23, 2019, 08:38:59 AM »
Hi
sorry if this was discussed before. I tried to sysex save a current state of my P12 module without it being saved as a user preset. When I re-transmitted the sysex it was not the snapshot that I had but instead it was the preset that was saved.
So my question(s):
Is it possible to take snapshots with sysex at all ( or should I buy the code-knobs editor forget all these troubles?)?
Thanks.