I have one of my setting wrongs, no doubt.
Right now, I have my P6 connected both in and out to my Digitakt, as I am also using the Digitakt to sequence the P6.
However, when I'm trying to use the P6 internal step sequencer, when I release the key, rather than incrementing one step, it increments two steps.
I suspect that it's getting a 2nd set of "note off" as an echo from the Digitakt.
Is there a way to maintain my two way connection to the Digitakt, and still use the P6 step sequencer?
1 Replies
1546 Views