The Official Sequential/Oberheim Forum

SEQUENTIAL/DSI => Tempest => Topic started by: JC14 on October 06, 2016, 05:27:59 AM

Title: How to record sounds as individual audio in DAW
Post by: JC14 on October 06, 2016, 05:27:59 AM

Hello.

Yes, a "dumb" question maybe. But I'd like to know how I can record each sound (pad) of my tempest as an individual (audio or midi) track in my DAW.
Can't seem to get it set up... Help is greatly appreciated :-)

Thanks!

Title: Re: How to record sounds as individual audio in DAW
Post by: Shea on October 06, 2016, 04:58:33 PM

you can't. the tempest is a 6 voice synth and has 6 voice outs. while each voice is stereo, you have at most 6 voices to which you can assign the various pads/sounds.

the voice assign screen can be found at the bottom of the sound screen when in 16 sounds mode.

Title: Re: How to record sounds as individual audio in DAW
Post by: Yorgos Arabatzis on October 06, 2016, 05:34:27 PM

With careful programming and chocking you can get more than 6 voices but simultaneously it's only 6..

Title: Re: How to record sounds as individual audio in DAW
Post by: JC14 on October 07, 2016, 01:45:15 AM

Ahhh that figures :-)
Thanks so much for your help! 

Title: Re: How to record sounds as individual audio in DAW
Post by: LucidSFX on October 07, 2016, 06:58:32 PM

Don't worry though. This is totally possible. Hard panning will help you get to 12 outs:) Remember feedback goes through the left channel so look at the sounds you are using carefully.

Title: Re: How to record sounds as individual audio in DAW
Post by: Shea on October 12, 2016, 04:54:28 PM

Quote from: LucidSFX on October 07, 2016, 06:58:32 PM

Don't worry though. This is totally possible. Hard panning will help you get to 12 outs:) Remember feedback goes through the left channel so look at the sounds you are using carefully.

wow, good point. i've never used more than 4 outs but it's nice to realize i have a 12 out drum synth if need be