The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Take 5 => Topic started by: psylhouette on March 14, 2023, 11:26:35 AM
-
Hi all
My oscillator calibration mode has been frozen for over an hour now (on voice 3, osc 1, freq 1)
No buttons or keys seem to be responding while it's been in this mode, but in the manual it says not to power down while calibration is in progress
Any tips?
-
Hi all
My oscillator calibration mode has been frozen for over an hour now (on voice 3, osc 1, freq 1)
No buttons or keys seem to be responding while it's been in this mode, but in the manual it says not to power down while calibration is in progress
Any tips?
Ugh. Contact support, yet?
Hadn't noted that you shouldn't power-off in the middle of a calibration cycle, but makes sense. Good luck.
-
Hi all
My oscillator calibration mode has been frozen for over an hour now (on voice 3, osc 1, freq 1)
No buttons or keys seem to be responding while it's been in this mode, but in the manual it says not to power down while calibration is in progress
Any tips?
Ugh. Contact support, yet?
Hadn't noted that you shouldn't power-off in the middle of a calibration cycle, but makes sense. Good luck.
Not yet no, going straight there next!
Thanks for getting back to me
-
Hi all
My oscillator calibration mode has been frozen for over an hour now (on voice 3, osc 1, freq 1)
No buttons or keys seem to be responding while it's been in this mode, but in the manual it says not to power down while calibration is in progress
Any tips?
Ugh. Contact support, yet?
Hadn't noted that you shouldn't power-off in the middle of a calibration cycle, but makes sense. Good luck.
Not yet no, going straight there next!
Thanks for getting back to me
They've been very responsive in my experience, fwiw.
-
Hi all
My oscillator calibration mode has been frozen for over an hour now (on voice 3, osc 1, freq 1)
No buttons or keys seem to be responding while it's been in this mode, but in the manual it says not to power down while calibration is in progress
Any tips?
Ugh. Contact support, yet?
Hadn't noted that you shouldn't power-off in the middle of a calibration cycle, but makes sense. Good luck.
Not yet no, going straight there next!
Thanks for getting back to me
They've been very responsive in my experience, fwiw.
Yes I hear their customer service is quite legendary!