The Official Sequential/Oberheim Forum

SEQUENTIAL/DSI => Evolver => Topic started by: Evoortone on August 26, 2022, 12:51:43 AM

Title: Stop sending in-between program changes?
Post by: Evoortone on August 26, 2022, 12:51:43 AM

Hi, is there a way to make the Evolver (Mono Key in my case) slow down a bit and not send all in-between program changes when scrolling? Like holding some button or something?

In my case the receiving unit (TC Fireworx) can't handle this and crashes trying to load many programs in a row and it's a bad idea anyway to send a lot of program changes like that.

Title: Re: Stop sending in-between program changes?
Post by: acemonvw on September 28, 2022, 10:24:35 AM

Quote from: Evoortone on August 26, 2022, 12:51:43 AM

Hi, is there a way to make the Evolver (Mono Key in my case) slow down a bit and not send all in-between program changes when scrolling? Like holding some button or something?

In my case the receiving unit (TC Fireworx) can't handle this and crashes trying to load many programs in a row and it's a bad idea anyway to send a lot of program changes like that.

I'd suggest getting a midi patchbay which can block program change messages. Unless you absolutely need to have them being sent out. That's been my workaround for Sequential/DSI gear.