The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Tempest => Topic started by: PacificState on June 20, 2022, 10:50:14 PM
-
I've just bought a second-hand Tempest and am noticing that voice 2 seems to be permanently panned hard left (ie there isn't a right channel component).
I initially discovered this by loading a kit and tapping pads until each sound round-robins, but it's very evident if I go into the voice assignment page and set the pad to 'V2'.
I've already run a calibration pass, and it's consistent across multiple projects - is there anything else I might have missed, or is this unit destined for repair?
-
I was able to fix it. Figuring it was a problem with a dirty switch in the Voice 2 jack, a combination of a.) a blast of compressed air, and b.) cleaning the jack with a Q-tip soaked in 99% isopropyl, resurrected the voice in the main outputs such that I could pan it - albeit that the left/right balance wasn't initially even, a problem which was fixed by a final recalibration.
I'm not sure this would be sanctioned by support, so caveat emptor/YMMV. Oddly, someone a few posts below has the same problem with the same voice...