The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Pro 3 => Topic started by: Gino.Cortesi on January 30, 2022, 05:54:53 PM
-
Hi Everyone,
Before I send this to support, I wanted to see if others have seen this behavior.
While using my PRO3 as a midi controller, after about 15 minutes of playing the notes start to get stuck.
The first thing I notice is that holding a key will not play a note, and releasing it will.
The only way I've been able to fix this is powering cycling the PRO3. I started seeing this since I updated to the latest OS (12.02.02).
Best regards,
Gino
-
Have the exact same issue, but only when using USB midi (hence you noticed when using as a midi controller, same here). After lots of trial and error I noticed it behaves normally from the midi DIN ports. Been back and forth with support about it, even swapped out a new board that they sent over, but issue remains. Must be a firmware thing, but sequential seems to not be able to replicate the issue. Contact support that you're having the same issue, would love to see a fix as well!
-
Thanks, that's good to know! I'm going to see what I can figure out first (make sure it's not a midi loop I have in my setup, etc), and then I'll contact support.
Best regards,
Gino
-
Same here. Every dozen minutes, the keyboard "reverses", so key off triggers key on. Very annoying bug, which is present since day one.
However, using DIN Midi works without issues.