The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => OB-6 => Topic started by: Kai-vD on December 18, 2021, 12:14:41 AM
-
I have a seaboard connented, Y-axis is CC74, but can't get the movements on the Y-axis to change any values (cutoff/pw).
The pitchbend on X-axis is working fine.
The new FW 1.7.4 is installed - can that cause this issue?
It worked before I updated my unit.
Where can I get the earlier FW-Version I had before?
-
Mine works ok after 1.7.4. I'm using my LFE which sends modulations on CC74 and the synth responds fine. Have you tried a globals reset? It can sometimes fix strange things after a firmware update.
1.7.4 also fixes a bug where program changes were sent as aftertouch commands when in MPE mode. Thanks Sequential :)
-
Don't know exactly why, but suddenly it's working. Thanks!