The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Pro 3 => Topic started by: Bential on September 24, 2021, 01:37:21 PM
-
Hi,
hope all is well.
Apologies, if this has already been suggested as a feature request.
The ability to have AUX ENV 1+2 to control FX_Parameters. Ref; Take 5
AUX ENV 1: Reverb_ Mix, Damping, Pre delay, Decay, EQ
AUX ENV 2: Effect x
It would be very cool, and maybe not hard to implement for next Beta?
-)
thanks.
-
Hi,
hope all is well.
Apologies, if this has already been suggested as a feature request.
The ability to have AUX ENV 1+2 to control FX_Parameters. Ref; Take 5
AUX ENV 1: Reverb_ Mix, Damping, Pre delay, Decay, EQ
AUX ENV 2: Effect x
It would be very cool, and maybe not hard to implement for next Beta?
-)
thanks.
You can do this... the destinations are named "FX 1 Param 1, FX 1 Param 2, FX 1 Mix, etc..." You just have to refer to the selected effect to figure out what each one is... would be nice if there was context sensitive naming in destination matrix... that would streamline things a bit.
-
The ability to have AUX ENV 1+2 to control FX_Parameters. Ref; Take 5
AUX ENV 1: Reverb_ Mix, Damping, Pre delay, Decay, EQ
AUX ENV 2: Effect x
There's no barrier to doing these assignments in the Pro 3 now, unless I'm misunderstanding the request.