The Official Sequential/DSI Forum

SEQUENTIAL/DSI => OB-6 => Topic started by: Luke Keywalker on August 09, 2021, 04:45:34 AM

Title: Can't turn Param Rcv ON (CC)
Post by: Luke Keywalker on August 09, 2021, 04:45:34 AM
Hey guys,

for some reason, I cannot turn "Param Rcv" on CC in my OB-6 Keyboard version. If I change to CC it always switches back to OFF automatically. I can only choose between OFF and CC and if I close Global Settings it goes back to OFF - so I am not able to draw filter curves etc. in Logic and play them back on the OB-6.

Any ideas?

Thanks a lot  :-*

Luke
Title: Re: Can't turn Param Rcv ON (CC)
Post by: Chevron on October 03, 2021, 03:09:41 AM
I have the same issue. I only set OFF and CC in the "Param Rcv" global setting. NRPN is missing.
Also I can't turn CC on, when I do and check the menu again it is set to off.
Title: Re: Can't turn Param Rcv ON (CC)
Post by: Chevron on October 05, 2021, 02:50:08 AM
Ah turns out it was a midi feedback issue. I adjusted a setting on my sequencer and the problem was solved.