The Official Sequential/Oberheim Forum

SEQUENTIAL/DSI => Prophet => Prophet Rev2 => Topic started by: greg smith on March 31, 2021, 01:05:17 AM

Title: Hold not working with the arpeggiator
Post by: greg smith on March 31, 2021, 01:05:17 AM

OS.1.1.5.9
Hello All,
Is there any reason that the hold function would not work with the arpeggiator?
I have a basic program, sync set to off. Hold works with arp off, but with the arp on, the hold button lights up,
but doesn't hold - instead all notes are cut and silence ensues.
The manual says it's supposed to work and I've tried all the global/misc parameters that I though might cause this behaviour but I can't fix the problem.
Greg

Title: Re: Hold not working with the arpeggiator
Post by: timboréale on March 31, 2021, 06:10:28 AM

If you have the system set up to require MIDI clock the Arp doesn't run unless the board is getting active clock right then. Are you sending it clock?

Title: Re: Hold not working with the arpeggiator
Post by: greg smith on March 31, 2021, 07:49:14 AM

No MIDI clock mode is set to 'off'