The Official Sequential/Oberheim Forum

SEQUENTIAL/DSI => Prophet => Sequential Prophet-6 => Topic started by: Abuwabu on March 18, 2021, 09:04:59 AM

Title: Prophet knobs not responding after update
Post by: Abuwabu on March 18, 2021, 09:04:59 AM

Hi guys.

Is there a way to completely reset the Prophet 6 to factory default beyond downloading patches over Sysex?

I updated the Prophet desktop to 1.6.7 via SysEx Librarian, and now the Prophet doesn't work properly.
It responds to MIDI data but every patch is an eerie dissonance which cannot be altered, none of the knobs work, and all the sequences have been wiped. It's totally useless (unless I want horror sirens).

I've already tried loading the factory presets again via SysEx Librarian, and although it completes properly there is no change.

Any suggestions?

Thanks
Abu

Title: Re: Prophet knobs not responding after update
Post by: timboréale on March 18, 2021, 11:11:08 AM

Did you reset your globals as suggested in the update notes?

Title: Re: Prophet knobs not responding after update
Post by: Abuwabu on March 18, 2021, 01:49:44 PM

Quote from: timboréale on March 18, 2021, 11:11:08 AM

Did you reset your globals as suggested in the update notes?

No. I didn't see that in the notes. And it was indeed the solution to the problem. All working.
Thanks a lot.

Title: Re: Prophet knobs not responding after update
Post by: thirteen_engines on March 19, 2021, 07:40:32 AM

If you were using the new vintage knob before updating, don’t forget to re-enable it. The global reset will flip it back to slop. That one got me for a bit ... couldn’t understand why my voices sounded so out of tune. :)