The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Prophet => Sequential Prophet-6 => Topic started by: Ben26 on February 26, 2021, 12:45:44 PM
-
https://www.sequential.com/updating-the-prophet-6-os/
8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8) 8)
-
Cool! Not sure what's new in this release, other than the correct firmware number but ...
Don't forget to reset globals with write + globals and then, if you'e using the vintage setting to reset it to vintage. I forgot that at the last firmware update and wondered why vintage wasn't working like before.
Cheers,
Keith
-
In my opinion it is the official version 1.6.6 which displays "1.6.7" at startup :) (it is better than "6.0.2" :-[)
I performed the update. It stuck at the end of the upgrade process (suddenly displaying "111" after the second countdown reached "1"). I waited 5 minutes and turn it off.
It displayed "1.6.7" when I turn it on few seconds after.
Upgrade successful. :)
-
Question to the Sequential team:
I have 1.66beta installed. Is there any reason (code changes, bug fixes) to update to 1.67, or is this just the name of the official version? I would prefer a definite answer over guesses.
-
Don't presume the Sequential staffers read every post here. They're busy working at home, so the communications are worse than usual. If you want a definitive answer from the mothership, contact them directly.
-
I get an E.r.1 error message after transfer...? Anyone had this before?
-
I performed the update. It stuck at the end of the upgrade process (suddenly displaying "111" after the second countdown reached "1"). I waited 5 minutes and turn it off.
It displayed "1.6.7" when I turn it on few seconds after.
Upgrade successful. :)
I had the same behavior on the second time I ran the firmware update. Works fine now. The first time I ran it, it never did either count down and the display showed "t 8". I tried to play a few patches and it was not right, but running it a second time fixed it.