The Official Sequential/Oberheim Forum

SEQUENTIAL/DSI => Mopho/Tetra => Mopho X4 => Topic started by: scottplant on January 11, 2021, 10:59:59 AM

Title: Replacing the rubber feet
Post by: scottplant on January 11, 2021, 10:59:59 AM

Hi, I know this is not a sophisticated operation, but I wanted to see if there was a best practice or anything worth knowing about replacing the rubber feet on the x4.

I was going to use E6000 glue to put it back in the original spot.

Again, seems very straight forward, but if there's anything I should know, or any upgrades I could make, that would be great. Thanks

Title: Re: Replacing the rubber feet
Post by: chysn on January 11, 2021, 01:27:54 PM

As I recall, Mopho feet just stick on, so E6000 or Gorilla Glue should do the trick. Let it cure for a couple days before jamming too hard on the keyboard.