The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Pro 3 => Topic started by: jym on September 29, 2020, 11:28:56 AM
-
Very hard to replicate this as it only happens intermittently. I will be using the cutoff knob and occasionally as I am decreasing the cutoff at a moderate pace, the encoder will hang at around 500-600 and very quickly jump to 100 or 200 when I decrease rapidly. It almost sounds like there's a momentary hang of frequency and then warping to the lower value. has anyone seen this? is this just normal behavior?
-
Reporting that we are not having that behavior on our Pro 3.
-
No. But FYI it’s a potentiometer not an encoder. I’d suggest reaching out to support.