The Official Sequential/Oberheim Forum

SEQUENTIAL/DSI => OB-6 => Topic started by: thepilgrimsdream on September 25, 2020, 06:19:30 PM

Title: Parameters don't change unless I turn the knob all the way
Post by: thepilgrimsdream on September 25, 2020, 06:19:30 PM

Whenever I switch presets and turn any knob, it doesn't respond until I turn it all the way open, then it jumps all the way to the maximum setting. Is this normal behavior?

Title: Re: Parameters don't change unless I turn the knob all the way
Post by: Manbird on September 25, 2020, 10:35:03 PM

Look up "pot mode" in the operation manual - it should solve your dilemma...

https://www.davesmithinstruments.com/wp-content/uploads/2016/03/OB-6-Operation-Manual.pdf?da8101 (https://www.davesmithinstruments.com/wp-content/uploads/2016/03/OB-6-Operation-Manual.pdf?da8101)