The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Pro 3 => Topic started by: W07 on August 19, 2020, 12:36:43 PM
-
'm trying to use the pro3 as a four-track gate/rythm sequencer for eurorack.
Not much luck so far.I've tried assigning a sequencer track to CV1TRIG, but then the CV1 out it starts sending a steady gate rythm at the tempo the sequencer division is in. muting or unmuting notes doesn't do anything. I can have this rythm stop by tie-ing a note to the next step. It will then stop, and resume as soon it reaches a new active step. The first step will hence always trigger.
I was hoping to set the destination to CVTRIG OUT, and being able to just sequence a rythm on that track by entering some steps with mutes in between. I'd think the value of the step would be the gate's intensity, so useable for dynamics.
Am i using it wrong, or is this functionality (the CV trig out) not implemented correctly yet?
-
bump-
I was hoping to get at least some reply from someone at DSI
-
I mentioned this (with a different issue) when I contacted DSI support. Right cv1 will only send steady 16ths. They formally put in a request to sequence triggers however you like, but for now, at least, it's 16ths only. Please note, contacting DSI diredclt through support email is THE BEST way to get them to respond. The forums are only slightly touched by DSI staff.
-
It's already on the bug list internally and something I'll probably work on this week. I read the forums regularly, I just don't respond very often to things
I mentioned this (with a different issue) when I contacted DSI support. Right cv1 will only send steady 16ths. They formally put in a request to sequence triggers however you like, but for now, at least, it's 16ths only. Please note, contacting DSI diredclt through support email is THE BEST way to get them to respond. The forums are only slightly touched by DSI staff.
-
It's already on the bug list internally and something I'll probably work on this week. I read the forums regularly, I just don't respond very often to things
Came here as I can't get CV Trigger outs to work as expected - is this fixed or still in development?
-
+1 for me on the CV trigger issue. Was informed to come here to post my request for this to be fixed ASAP...
-
Came here looking for an answer too. Hope this is resolved soon.
-
+1 for this. Would be a much more flexible if this was implemented! :)
-
+1 for this. Would be a much more flexible if this was implemented! :)
This was actually fixed in the last firmware update!
-
+1 for this. Would be a much more flexible if this was implemented! :)
This was actually fixed in the last firmware update!
Hey im having this same issue. do you know if this firmware update is out yet? Or were to find it? I just installed the new os but no luck.