The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Mopho/Tetra => Mopho X4 => Topic started by: gonzalobd on July 08, 2020, 02:33:29 AM
-
Hi!
I own a brand new mopho x4 since 5 years ago. Recently I started playing sequenced arps with it ( I only played manual notes/chrods until now) and I'm facing an issue with the volume.
When I sequence a few notes and I let them playing, If I turn low the volume knob to 0, it turns up again progressively by itself, after a few seconds.
This happens with the arp latch mode (no midi/usb connections at all, so its not a midi issue) and sequencing the notes from ableton with usb or midi cable
The synth firmware is updated with latest version, and I already tried with a global reset
Any idea what's happening?
Thanks!
-
Already reported to DSI/Sequential technical service. Waiting to receive a new replacement pot. :)
-
Hey there,
Same problem here.
Was it a broken volume knob?
Best