The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Pro 3 => Topic started by: tarekith on April 28, 2020, 10:54:11 AM
-
http://innerportalstudio.com/downloads/Pro3PB.MOV
(http://innerportalstudio.com/downloads/Pro3PB.MOV)
Does anyone else have an issue with their PB Wheel being very loose? Mine has been making an intermittent grinding noise since I got it, but today I noticed the wheel itself has become VERY loose in the case. Anyone from Sequential know how easy it is to access this if I open up the case? I'm pretty handy and have opened up many of my synths in the past to make small fixes like this, I just don't want to waste the time trying if it's not something I can access easily.
Side Note: the cutoff knob on my SE Pro 3 was also incredibly loose, it was barely attached to the front panel. That happily was an easy fix and now it's fine.
-
Have the standard version and mine are fine , filter knob too.
-
Mine came with a loose mod wheel. It is an easy fix. remove the 4 or 5 screws holding the housing, I luckily had a very thin wrench the correct size. You'll see.
-
Thanks, in contact with sequential now about it. Appreciate the advice.