The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Prophet => Sequential Prophet X => Topic started by: blewis on February 15, 2020, 08:12:00 AM
-
Basically my Prophet X refuses to update all OSes by USB.
After following the proper instructions - which I read every time because it never works - I attempt to update via USB and the the synth inevitably will not start up after reporting that it has successfully updated the firmware.
This time I waited 3 full minutes after it reported it was done and ready to be reset. Then I let it sit powered off for a full minute before turning it on.
Nothing.
A quick flash of the screens, then complete darkness with the sliders 1/2 lit and the mod wheels lit.
Now I have to go dig up the Sys EX update - again - like I have to do every time.
Am I the only person in the world that has to do this every single time?!
-
I’ve had the same issues with the most recent betas.
I’m about to try 2.2 and will report back!
-
Gah. Same thing.
On restart nothing happens except a few lights and a glitchy readout on the effects screen.
Is there a sysex for 2.2 available?
I’ve submitted a support ticket linking to this thread.
-
Okay. Thanks for reporting back. Nice to know I’m not alone here. I emailed support too. I’m sure they’ll send us the SysEx early next week.