The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Prophet => Prophet Rev2 => Topic started by: PadburyMusicIan on January 18, 2020, 06:44:35 PM
-
I know to go to misc parameters on the synth and scroll through to layer Volume, toggle between layer A & B to get direct access to both the value of the layer volumes and turn the value knob to adjust layer volumes.
I know to go to the SoundTower editor and use the onscreen emulation of those two volume knobs in the Globals window.
But this is very long winded for such a simple need, to turn layers up and down during a performance.
I can also use both layer outputs on the back of the synth through 2 stereo channels of a mixer and then use the mixer to blend the volume of the two layers, which is fast, but I don't want to go that way if i can achieve this with MIDI controller mapping.
I have MIDI controllers that accept instructions to flash memory of what type of messages to send per knob and button, is there is a way to use these editable MIDI controls to access and control these two layer volumes directly?
Is the SoundTower application able to accept MIDI mapping to controllers? I don't see that anywhere in the menus.
Is there a way to allocate a particular NRPN or CC that goes straight to this volume adjust on the synth?
Hoping there is a range of good options for this.
Thanks
-
NRPN (MSB, LSB):
Layer A Volume: 0, 29
Layer B Volume: 16, 29
I haven't used CC, but it's listed in the manual as CC #37. Doesn't say anything about layers though, but #38 isn't listed so perhaps it could be Layer B's volume? Otherwise I suspect you'd have to set the Rev2 to multi and send CC #37 on separate MIDI channels, but that's just a guess. Use NRPN if you can, in case you should want to control other parameters later on.
-
With NRPN’s you can do this, with CC’s probably not. There should be more public acknowledgement that CC’s aren’t in the cards with MIDI routing for the rev 2 (too many parameters). Would save a lot of people a lot of time.