The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Pro 2 => Topic started by: ARNK on December 25, 2019, 07:34:51 PM
-
What you're looking at here is a single oscillator sine wave. I've noticed this for a long time, but all patches lean slightly to the left speaker in regard to levels and other metering software as you see in the image. In fact, it's only ever been this way. Is your signal straight down the middle?
-
Under Assign Source, Pan can be adjusted by a DC Offset of -5. This corrects the panning issue, but every preset is off by this amount. I've saved a basic program with this adjustment, but how can I apply it to all factory sounds? Is there a way to hack the Fixed Mods?
-
Can't say I've noticed this. Might be easier to just balance with a mixer if you use one
-
Can't say I've noticed this. Might be easier to just balance with a mixer if you use one
Not a bad point.