The Official Sequential/DSI Forum

SEQUENTIAL/DSI => Mopho/Tetra => Mopho X4 => Topic started by: studio460 on September 07, 2019, 10:54:04 PM

Title: Mopho x4: no sounds用atch-names not changing . . .
Post by: studio460 on September 07, 2019, 10:54:04 PM
I just turned my Mopho x4 on after a few months of disuse (not stored曜ust sitting in a home studio bedroom not being played). No sound comes out. Also, the patch-name doesn't change as I turn the pots through the various patches/banks (i.e., the patch-number and bank-number are changing on the display, but the display's patch-name remains unchanged).

I disconnected all cables耀till no sound even through headphones. Any ideas? Recent firmware installed; performed several hard power-cycles, keyboard = "on," etc. . . .
Title: Re: Mopho x4: no sounds用atch-names not changing . . .
Post by: chysn on September 09, 2019, 02:55:02 PM
Make sure that local control is on.
Title: Re: Mopho x4: no sounds用atch-names not changing . . .
Post by: studio460 on September 10, 2019, 05:32:59 AM
Boy, do I feel dumb! That was it! Thank you chysn! I have no idea how that got switched to "off!"
Title: Re: Mopho x4: no sounds用atch-names not changing . . .
Post by: chysn on September 13, 2019, 02:26:12 PM
You're welcome  :)