The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Prophet => Prophet Rev2 => Topic started by: Nsemest182 on August 08, 2019, 12:21:01 PM
-
I created a sequencer using the built in sequencer and when I hit play it works as it should and plays the sequence through my Korg Ex-800. When I hit play IN MY DAW the sequence is all messed up and super fast. My Rev 2 is set to Slave (it does the same thing when in Master) and my DAW is set to Transmit Midi Data/Start/Continue/Stop/Clock. Anyone know where I could be messing this up?
-
Not sure I fully understand, but you might want to check the tempo in your DAW.
-
I created a sequencer using the built in sequencer and when I hit play it works as it should and plays the sequence through my Korg Ex-800. When I hit play IN MY DAW the sequence is all messed up and super fast. My Rev 2 is set to Slave (it does the same thing when in Master) and my DAW is set to Transmit Midi Data/Start/Continue/Stop/Clock. Anyone know where I could be messing this up?
This very much sounds like a MIDI loop, or the clock signal is sent multiple times over the MIDI bus. Check which devices are sending clocks, there should only be one clock source on the same bus (cable).