The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Prophet => Sequential Prophet-6 => Topic started by: tk03i on June 05, 2019, 10:31:11 AM
-
Hi there,
I have a new Prophet-6 module and the manual instructs to use for output: "Unbalanced, 1⁄4 inch audio outputs."
I would like to connect the P6 to my audio interface (Babyface Pro) which has two XLR Female inputs available – but I'm a little uncertain on what cables I can use; unfortunately I'm not so technical to be honest.
Should I use 2x 1/4" mono cables on the P6 end, and 2x XLR Male (3-pol) plugs on the other end [2x because of separate L/R outputs of the P6]?
I'm wondering, because aren't XLR Male (3-pol) plugs actually balanced – thereby going counter to the instruction to use something "unbalanced"? Or does that only matter on the P6 end of the cables?
Is there a better solution, like using two 1/4" mono cables that converge into one XLR cable (which would be unbalanced)? Just curious – since I'm doubting that it's the right way (again, I don't have the technical expertise).
Secondly, how do I know if a 1/4" cable/plug is unbalanced or not?
-
What I do with my keyboards is to run unbalanced 1/4” cables to a stereo DI box and then balanced XLRs from there to my mixer. Works fine.
-
What I do with my keyboards is to run unbalanced 1/4” cables to a stereo DI box and then balanced XLRs from there to my mixer. Works fine.
Thanks for the suggestion. Do you use two separate balanced XLR cables for L and R to your mixer?
-
Yes. Two 1/4” unbalanced from the Prophet to the DI and two balanced XLRs from the DI to the mixer.