The Official Sequential/Oberheim Forum

SEQUENTIAL/DSI => Prophet => Prophet 12 => Topic started by: ooshadar on February 23, 2019, 08:38:59 AM

Title: Saving a snapshot with Sysex?
Post by: ooshadar on February 23, 2019, 08:38:59 AM
Hi
sorry if this was discussed before. I tried to sysex save a current state of my P12 module without it being saved as a user preset. When I re-transmitted the sysex it was not the snapshot that I had but instead it was the preset that was saved.
So my question(s):
Is it possible to take snapshots with sysex at all ( or should I buy the code-knobs editor forget all these troubles?)?
Thanks.