The Official Sequential/DSI Forum

SEQUENTIAL/DSI => Prophet => Prophet Rev2 => Topic started by: Robot Heart on June 15, 2017, 11:18:48 AM

Title: Newest Prophet Rev2 BETA OS - v1.1.5.9
Post by: Robot Heart on June 15, 2017, 11:18:48 AM
ALWAYS BACKUP YOUR IMPORTANT WORK VIA SYSEX DUMP BEFORE ATTEMPTING ANY OS UPDATES!!
It is highly unlikely to incur data loss from an OS update attempt, but always better safe than sorry. Just remember, you're never going to say to yourself "Man, I wish I'd backed that up before starting..."

The OS can be updated via USB or MIDI DIN.
We do not recommend using the following MIDI interfaces for SysEx transfers as we have had multiple users experience problems with them:
Native Instruments Maschine
Digidesign Mbox/Mbox2
Digidesign 001/002
CME U2MIDI

 Rev2 OS update instructions for Mac or PC (https://www.sequential.com/updating-prophet-rev2-os/)

To check if the OS update was properly installed, go to the Global menu by hitting the 'Global' button. The OS version is displayed in the bottom right corner.

If your OS load countdown doesn't complete:

Main OS 1.1.5.9

Main OS 1.1.5.6

Main OS 1.1.5.1

Main OS 1.1.5


Main OS 1.1.4.27


Main OS 1.1.4.26

Main OS 1.1.4.25 - Release Candidate

Main OS 1.1.4.18

Main OS 1.1.4.13

Main OS 1.1.4.9

Main OS 1.1.4.5

Main OS 1.1.4.4

Main OS 1.1.3
**NOTE: Global L/R Balance parameter added in OS version 1.1.0.6  has been removed.**
**NOTE: You must recalibrate the oscillators and filters after installing OS 1.1.3.**

Main OS 1.1.0.6
**Note: after updating to OS version 1.1.0.6, you must:**

Main OS 1.1.0.3

Main OS 1.1.0.2

Main OS 1.1.0.1
**NOTE: You must recalibrate the oscillators and filters after installing OS 1.1.0.1**


Main OS 1.0.9.4

Main OS 1.0.7.2

Main OS 1.0.6.5

Main OS 1.0.6.2

Main OS 1.0.5

Main OS 1.0.4

Main OS 1.0.2
[/list]
Title: Re: Newest Prophet Rev2 BETA OS - v1.1.5.9
Post by: cbmd on February 04, 2019, 11:30:42 AM
New beta OS version 1.1.5.9 is available!

If you note issues with the oscillators following the update, please calibrate the wheels, clear all calibration data from the synth, and recalibrate the oscillators/filters thereafter.

Calibrate the Wheels: Press the GLOBAL button, navigate to the CALIBRATE WHEELS menu item, and press the WRITE button.  Follow the onscreen instructions to perform the wheel calibration.

Clear Calibration Data: Hold both TRANSPOSE buttons and press the GLOBAL button.  Navigate to the CLEAR CALIBRATION menu item and press the WRITE button.

Calibrate oscillators/filters: Press the GLOBAL button, navigate to the CALIBRATE menu item, press the WRITE button.  The calibration will commence and its progress will be shown on screen.

**If you're updating from below OS 1.1.3, you must:**

Perform a Global Parameters Reset
Recalibrate oscillators/filters

If you are updating from 1.1.3 or above, these steps are not necessary.