The Official Sequential/DSI Forum

SEQUENTIAL/DSI => Pro 2 => Topic started by: MDMA on April 14, 2017, 09:09:36 AM

Title: A couple of questions
Post by: MDMA on April 14, 2017, 09:09:36 AM
Hi

I was hoping someone could clear up a couple of questions I had....

1. How on earth do I pan the oscillators? I can pan them with an lfo, but where is the pan ?

2. If I record a sequence, can I then record that straight into my sequencer ?

Forgive me if these questions have been asked before on here. I have searched but wanted to start a new discussion.
Title: Re: A couple of questions
Post by: martin3 on April 14, 2017, 12:59:44 PM

Hi,

use the DC in the modmatrix and select Pan as destination to pan all oscilators at once. The panning of the delays is also movable. Spreaded oscillators would be merged to mono in the filters.

The sequencer can send out MIDI notes if you want it to do so select a track and the destination OUT1 or OUT2.

Hope this helps,

Martin3
 
Title: Re: A couple of questions
Post by: MDMA on April 14, 2017, 03:32:08 PM
Thank you for your reply Martin3, though how do I pan individual oscillators?
Title: Re: A couple of questions
Post by: martin3 on April 14, 2017, 04:09:04 PM
Thank you for your reply Martin3, though how do I pan individual oscillators?

Hi,

individual panning is not possible. Only very few synths have stereo filters and allow that.

Happy weekend,

Martin3
Title: Re: A couple of questions
Post by: MDMA on April 15, 2017, 11:08:54 AM
Really? Wouldn't of thought it would be that difficult tbh!

Shame.
Title: Re: A couple of questions
Post by: pbzoot on April 16, 2017, 05:57:42 PM
Nobody said it's difficult. Just expensive