The Official Sequential/Oberheim Forum

SEQUENTIAL/DSI => Prophet => Prophet Rev2 => Topic started by: thehay95 on June 18, 2019, 01:49:55 AM

Title: Recall last Preset/Setting after reboot
Post by: thehay95 on June 18, 2019, 01:49:55 AM

New to the Rev2 and I’m wondering why when I turn off the unit and turn it back on, it shows the last patch used for a split second, then REV2 logo show up and then switches to a different random patch.

Is there a way to set it up so it boots up with the last patch used?

Apologies if this has been discussed already.

Title: Re: Recall last Preset/Setting after reboot
Post by: gernotreininger on June 18, 2019, 01:58:13 AM

Quote from: thehay95 on June 18, 2019, 01:49:55 AM

New to the Rev2 and I’m wondering why when I turn off the unit and turn it back on, it shows the last patch used for a split second, then REV2 logo show up and then switches to a different random patch.

Is there a way to set it up so it boots up with the last patch used?

Apologies if this has been discussed already.

If you want the rev2 to start with a desired patch, load the patch, go to globals and exit. Then the rev2 will start with it.

Title: Re: Recall last Preset/Setting after reboot
Post by: Pym on June 18, 2019, 05:00:12 AM

It's what was last in RAM in the OLED basically, which is displayed when powered up

Quote from: thehay95 on June 18, 2019, 01:49:55 AM

New to the Rev2 and I’m wondering why when I turn off the unit and turn it back on, it shows the last patch used for a split second, then REV2 logo show up and then switches to a different random patch.

Is there a way to set it up so it boots up with the last patch used?

Apologies if this has been discussed already.