The Official Sequential/Oberheim Forum
SEQUENTIAL/DSI => Pro 2 => Topic started by: goodweather on May 24, 2017, 02:44:36 AM
-
Hi,
I'm finalizing a Prophet 12 Ctrlr panel based on the one I made for the Pro2.
Came to the Delays filter mode (low-pass / high-pass) selection that exists on the Prophet12 but not on the Pro2.
So, how is it working on the Pro2?
- on the Pro2, is there one LPF and one HPF at the same time?
- on the Prophet12, is it one OR the other depending on the filter mode choice?
Thx for some info on this!
-
Hi,
I'm finalizing a Prophet 12 Ctrlr panel based on the one I made for the Pro2.
Came to the Delays filter mode (low-pass / high-pass) selection that exists on the Prophet12 but not on the Pro2.
So, how is it working on the Pro2?
- on the Pro2, is there one LPF and one HPF at the same time?
- on the Prophet12, is it one OR the other depending on the filter mode choice?
Thx for some info on this!
On the Pro-2 delay FX sections, both the LPF and the HPF are active at all times; there is no mode setting to select between the two, as on the Prophet-12.
I can't speak to the mode settings on the Prophet-12, to be honest–probably best to move this question over to the Prophet-12 section.
-
On the Pro-2 delay FX sections, both the LPF and the HPF are active at all times; there is no mode setting to select between the two, as on the Prophet-12.
Thx David, that was my impression too (I have the Pro2...)