The Official Sequential/Oberheim Forum

SEQUENTIAL/DSI => Prophet => Prophet Rev2 => Topic started by: bleen on October 08, 2022, 03:52:41 PM

Title: Can't change patches after display sleep
Post by: bleen on October 08, 2022, 03:52:41 PM: Howdy!

I just purchased a second-hand Rev2; it sounds lovely and is a blast to program, but when I wake it up after the display has slept, I can no longer scroll through patches, either user or factory. Whatever patch/bank it was on when it went to sleep is where it stays until I reboot the synth. I couldn't find this issue previously being reported here searching the forum.

I have updated the unit to 1.2.0 and recalibrated since doing so.

Thanks!
Title: Re: Can't change patches after display sleep
Post by: AlainHubert on October 10, 2022, 11:42:45 PM: Quote from: bleen on October 08, 2022, 03:52:41 PM
Howdy!

I just purchased a second-hand Rev2; it sounds lovely and is a blast to program, but when I wake it up after the display has slept, I can no longer scroll through patches, either user or factory. Whatever patch/bank it was on when it went to sleep is where it stays until I reboot the synth. I couldn't find this issue previously being reported here searching the forum.

I have updated the unit to 1.2.0 and recalibrated since doing so.

Thanks!

I believe the latest firmware revision is 1.2.1.
Perhaps you could install it?
Title: Re: Can't change patches after display sleep
Post by: bleen on October 11, 2022, 09:13:11 AM: Quote from: AlainHubert on October 10, 2022, 11:42:45 PM
I believe the latest firmware revision is 1.2.1.
Perhaps you could install it?

I was incorrect in my original post; I have 1.2.1 installed.
Title: Re: Can't change patches after display sleep
Post by: AlainHubert on October 11, 2022, 10:21:45 PM: Ok then. Something seems wrong with your REV2. The only time on mine when I can't change programs or banks is if I'm on the Globals page.